WEIGH IN MOTION WEIGHBRIDGES

WEIGH IN MOTION WEIGHBRIDGES

WMS Model AWS110 Single Axle Weigher

WMS110 Single Axle Weigh In-Motion (WIM) is manufactured in Australia, incorporating quality stainless steel NMI approved weighbridge load cells in this model. The WMS110-WIM Pit Weighbridge is a composite design using a combination of structural beams & heavy floor plate with reinforced concrete insert. The Standard AWS 110 is quality durable design to the Latest Australian Standard for Bridges AS/NZS 5100-2004. The design incorporates deck & gusset supports long the beams; this may give greater strength than other weighbridges offered imported from China or of lesser quality. The WIM integrates into existing or purpose built pavements, with particular attention necessary to the level approaches either side of the instrument

As the name suggests the vehicles via the connected Weigh In-Motion Software can capture and record the weight of each axle & calculate a group with the vehicle travelling at low speed. Ideally the levels either side of the weighbridge should be as close to level for the length of the vehicle being weighed. Proven accuracy can be expected with level approaches within +/- 2%, with smooth entry & exit pavement either side of the WIM. 

The WMS Load Management Software & Unmanned Kiosk provides a full automated weighing process and lane, there is no need for dedicated staff. The vehicle operator has a known ID or has been issued electronic identification for the system. The Control suite can coordinate traffic signals and gates as standard. The systems can integrate with site SCADA via Modbus.


Easy installation 

2 day turn around on installations after civils

3M Weighbridge

20t Capacity

Galvanized body structures 

In-ground 

Equipped with Analog load cells

Contact Us


All of our products have been designed and manufactured to operate in the often harsh Australian climate.


Share by: